tqhq.ee foorum - BAP andur


register \| account recovery \| profile \| help / abiinfo \| search show today's posts \| mark all read

Poster	Message
Kert	BAP andur Küsimus järgmine..... Fordi 5.0 mootoril on sihuke asi nagu BAP sensor mis on kinnitatud tuleseina külge. Paremal pool on on pistik ja vasakul on vaakumi ots, probleem on selles et ei tia kuhu selle vaakumi otsa peaks ühendama....?
10.04.2001 at 12:09
rustang Moderator	BAP andur BAP sensor MAF-ga autol on sama mis MAp sensor speed densitomeetriga autol. Ehk on järgnevast abi? Võid ka tulla minu kapoti alla uurima, kuhu se asi yhendet on The MAP sensor is usually connected to the vacuum tree also. The two smaller fittings are connected to the fuel pressure regulator and to the line that supplies the EVP, TAD, and TAB solenoids. The single large fitting facing forward connects to the charcoal canister purge valve. If you vehicle is not equipped with a charcoal canister, then this line needs to have a small breather filter attached beyond the canister purge solenoid. The injectors and Idle Air Bypass Valve are calibrated for the additional air coming in from the canister purge. An orifice may be required in the canister purge line to control air flow if the canister is not used.
10.04.2001 at 12:49
Kert	BAP andur Millal saaks vaatama tulla?
10.04.2001 at 12:55
rustang Moderator	BAP andur Kert, saatsin vastuse maili peale, loodan, et said kätte.
10.04.2001 at 13:01